HERCULES TD-901T FORCE DRYER WITH HEATER

Hercules TD-901T Dryer with Heater & Single Motor has a lower noise output and the dryer housing unit is now made in a seamless weld, and improved seals reduce the total noise output & the dryer comes with an expandable /flexi hose and 1x sweeper nozzle and 1x round nozzle

Longer carbon brush of 38mm (1.5″), is the longest currently on the market and smaller sparks created by smaller carbon pellets and smoother rotor give the TD-901T a longer lifespan (by 30%) compared to the previous model.

Powerful motor delivers a high volume of regulated warm air to blast water from coats without damaging coats due to overheating.

Special designed solid state variable speed control device is the answer for various drying needs

A better air flow system and a smaller flow friction force, has allowed TD-901T to perform at a higher energy efficient ratio, yielding a 30% savings in energy consumption over previous models.

A better air flow system and a smaller flow friction force has allowed this dryer to perform at a higher energy efficient ratio.

One-click Easy Operation: allows operator to remove nozzle head with use of just one finger, with a simple click of the attachment.

With heater function useful for the cold weather as this Dryer is equipped with a 3 meters puncture-resistant, triple reinforced flexible hose

Constructed of rugged, durable steel and built to blast, with non-skid tabs on bottom with dual mounted legs, which allow both vertical and horizontal use

The filter is washable and easy to replace.

Total Wattage: 1800

Voltage:240

Maximum Temperature:52 Celsius

Weight: approx. 5kgs

Larger 52mm diameter hose

Dryer Maintenance

Step 1 – Unplug the dryer and take out the cap and filter which are located at the rear exterior of the dryer. Use a vacuum cleaner or a big brush to clean the cap and foam filter. You may find the cap and filter accumulated with animal dander, debris, and hair all over it. It must be cleaned thoroughly.

Step 2 – Later take the foam filter then scrub and clean it so that the bacteria and odour are gone then allow the filter to dry off before placing back in the Dryer.

This Dryers brush life is approx. up to 300 working hours and brushes should be checked and replaced within this timeframe.

(12-month warranty for Dryer Only) excluding hose, carbon brush, handle, nozzle and cord